Cisco Systems 5.4.x

28-9

UserGuide for Cisco Digital Media Manager5.4.x

OL-15762-05

Chapter28 Emulate the DMP Remote Control for Use with Cisco Cast

Procedures

Step5

Choose an option from the Security PIN behavior list.

Although CiscoCast randomly generates all of its emulator PINs, the fixed and dyna mic types differ in

their persistence.

•

Fixed—These PIN s persist until the PIN management type is changed.

•

Dynamic—These PINs expire and are then regenerated after an update interval that you define.

No two DMPs in your network will use the same PIN at any one time.

Step6

(As Needed) Did you choose the dynamic PIN type in Step 5?

If so, enter at least one digit in the Security PIN update interval (minutes) field.

The interval cannot be any less than 2 min. When you do not enter any value, Cisco Cast uses its

factory-default interval of 5 min.

Step7

Enter a shortened URL in the Access URL field for a page that will redirect ultimately to

http://<DMM_hostname>:8080/etv-remotecontrol-webapp/app/index.htm.

Note The shortened URL must not be more than 24 characters long.

Step8

Click Save.

Click Cancel to discard your selections and start over again.

Step9

Deploy the new emulator settings to your DMPs.

Click Content Management on the Home page.

Choose Digital Media Players > DMP Manager.

Choose the DMP or DMP group that should use these settings.

Choose Cast from the Actions list. Then, click Go.

Step10

Stop. You have completed this procedure.