Chapter 5 Replacing Cisco ASR 9001 Router Components

Removing and Replacing AC or DC Power System Components

Figure 5-1 Removing or Installing the Fan Tray on the Cisco ASR 9000 Series Router Chassis

332382

To install a fan tray into the chassis:

Step 1 Lift the fan tray (with two hands) and slide it halfway into the module bay.

Step 2 Slowly push the fan tray into the chassis until it mates with the backplane connector at the back of the module bay.

Caution To prevent damage to the connectors, do not use excessive force when inserting the fan tray into the chassis.

Step 3 Tighten the captive screw(s) on the fan tray to a torque of 10 +/–1 in-lb to secure it to the chassis.

Step 4 Verify that the (green) OK status indicator on the front of the fan tray goes on. If the OK indicator does not light, see the “Troubleshooting the Cooling Subsystem” section on page 4-18.

Removing and Replacing AC or DC Power System Components

This section contains removal and replacement procedures for the AC and DC power systems used in the Cisco ASR 9000 Series Router.

Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

 

OL-26701-02

5-3

 

 

 

Page 91
Image 91
Cisco Systems ASR9001s, 9001S manual Removing and Replacing AC or DC Power System Components