Chapter 5 Replacing Cisco ASR 9001 Router Components

Removing a Chassis from the Equipment Rack

Figure 5-2 Removing or Installing an AC or DC Power Module

332383

Installing an AC or DC Power Module

To install an AC or DC power module (see Figure 5-2):

Step 1 Slide the power module into the bay until it mates with its backplane connector.

Step 2 Make sure that keying lever locks with the chassis.

Step 3 Verify that the OK (green) power indicator on the front of the power module comes ON. If the indicator does not light up, see the “Troubleshooting the Power Subsystem” section on page 4-3.

Removing a Chassis from the Equipment Rack

Use this procedure to remove the chassis and its components from the equipment rack:

Warning You must use two people to remove the chassis from the equipment rack safely. An empty chassis can weigh up to approximately 24.69 pounds (11.2 kg).

Step 1 Power off the router (see the “Powering Off the Router” section on page 5-2).

Step 2 Power off the circuit breakers to the power supplies.

Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide

 

OL-26701-02

5-5

 

 

 

Page 93
Image 93
Cisco Systems ASR9001s, 9001S manual Removing a Chassis from the Equipment Rack, Installing an AC or DC Power Module