Cisco Systems ASR9001s, 9001S manual Installing a Cable Management Bracket

Chapter 3 Installing Modules and Cables in the Chassis

Cable Management

Cable Management Bracket

The Cisco ASR 9001 Router provides a cable management bracket at the middle of the router chassis. Figure 3-8shows a typical cable routing for the Cisco ASR 9001 Router.

Figure 3-8 Example Cable Routing through Cisco ASR 9001 Router Cable Management Brackets

332699

Note When shipped, the cable-management bracket is not attached to the router chassis. You must attach the cable-management bracket to the chassis before you insert the cables into the line card ports.

Caution Do not use the cable-management bracket as a handle to pull out or push in the line card. The cable-management bracket is designed to hold the interface cables and may break if you use the bracket to push, pull, or carry the line card after it is removed from the router.

Installing a Cable Management Bracket

To install a cable-management bracket, follow these steps:

Step 1 Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.

Step 2 Position the cable-management bracket over the front of the chassis front panel.

	Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
3-14	OL-26701-02