If the system is not configured to auto boot, it stops at the ROM DONE message. The console displays a rommon> prompt.

Chapter 1 Basic Troubleshooting Tasks and Startup Issues

Cisco uBR10012 System Startup Sequence

Table 1-1 Cisco\ uBR10000 Series System Startup Sequence

Startup Event

Event Description

PEM is powered off

The Fault LED on each PEM is lit yellow to indicate that power is being supplied to the PEM

 

but that the router is not turned on.

 

 

 

Power on the

1.

The Power LED on each PEM is lit green.

Cisco uBR10012 router

2.

The yellow Critical, Major, and Minor alarm and Fail LEDs illuminate for about 2 seconds.

 

 

3.

The alphanumeric display on the active PRE-1 module counts up through a range of

 

 

numbers from 1111 to 9999 (1111, 2222, and so on).

 

4.

The alpha numeric display counts up through a sequence of letters from AAA to CCC

 

 

(AAA, BBB, and CCC).

 

5.

The message ROM DONE appears on the alphanumeric display.

Note

6.The Power LED on each TCC+ card turns green. The Status LED on each TCC+ lights yellow. After a few seconds, the Status LED on the primary TCC+ card lights green, and the Status LED on the backup TCC+ card begins blinking green.

Cisco IOS software loads 1. If the system is set to boot from the slot0: file system, the green slot LED lights.

2.The message BOOT IMGE appears on the alphanumeric display on the active PRE-1 module.

3.The console displays a series of pound signs (#) as the IOS software image is decompressed.

4.The following messages appear on the alphanumeric display on the active PRE-1 module.

IOS STRT

IOS EXC

IOS FPGA

IOS FPOK

IOS FILE

IOS STBY

IOS DRVR

IOS LIB

IOS MGMT

IOS CONF

5.The console displays the bootup screen, followed by the prompt:

Press RETURN to get started!

6.The message IOS RUN appears in the alphanumeric display on the active PRE-1 module. In a redundant configuration, the message IOS STBY appears on the alphanumeric display of the standby PRE-1 module.

If the boot process fails, no console access is available. If you cannot boot the Cisco uBR10012 router, call Cisco TAC.

Cisco uBR10012 Universal Broadband Router Troubleshooting Guide

1-6

OL-1237-01

 

 

Page 18
Image 18
Cisco Systems UBR10012 manual Startup Event Event Description