Cisco Systems UBR10012 manual Unsupported Commands, Unsupported Frame Relay Commands

A P P E N D I X A

Unsupported Commands

The following are lists of the commands that are present but not supported for the

Cisco uBR10012 router in various releases of the Cisco IOS software.

•Unsupported Frame Relay Commands, page A-1

•HCCP Commands, page A-2

•MLPPP Commands, page A-2

•Unsupported MPLS VPN Commands, page A-3

•Unsupported PPP Commands, page A-3

•Spectrum Management Commands, page A-3

•Unsupported Telco-Return Commands, page A-3

Warning Cisco strongly advises against using unsupported Cisco IOS commands, even if described, because such commands can have undesirable effects upon the performance of the Cisco CMTS. In particular, Cisco advises against using any unsupported commands that pertain to service-policy or to Modular Quality of Service command-line interface (MQC) while Parallel Express Forwarding (PXF) is running on the Cisco CMTS.

Such commands may cause the Cisco CMTS to hang with unpredictable recovery times.

Unsupported Frame Relay Commands

The following commands are not supported in any Cisco IOS software release.

•FRF.12 fragmentation commands

•FRF.11 VoFR commands

•frame-relay adaptive-shaping {becn foresight}

•frame-relay bc {in out} bits

•frame-relay be {in out} bits

•frame-relay cir {in out} bps

•frame-relay custom-queue-list list-number

•frame-relay de-group group-number dlci

•frame-relay ip [rtp tcp] header-compression [passive]

•frame-relay map protocol protocol-address dlci [broadcast] [ietf cisco] [payload-compress {packet-by-packet frf9 stac [hardware-options]}]

Cisco uBR10012 Universal Broadband Router Troubleshooting Guide

OL-1237-01 A-1