Cisco Systems UBR10012 PRE Module Not Supported, PRE-1 Module Status Screen, Message Description

Chapter 3 Troubleshooting PRE-1 Modules

PRE Module Not Supported

PRE Module Not Supported

The Cisco uBR10012 router supports only the PRE-1 module in Cisco IOS Release 12.2(8)BC1, and later releases. If you attempt to boot the Cisco uBR10012 router with a PRE module with one of these software releases, the router prints the following error message and falls through to the ROM monitor:

%%Error: PRE not supported with this image

rommon>

To correct this error, replace the PRE modules in the router with PRE-1 modules. To continue using the original PRE modules, you must be reload the router with Cisco IOS Release 12.2(4)BC1 or an earlier 12.2 BC release.

Note For information on the replacement of PRE modules with PRE-1 modules, see the Field Notice, Cisco uBR10000 Proactive Upgrade of PRE to PRE1, at the following URL:

http://www.cisco.com/en/US/products/hw/cable/ps2209/products_field_notice09186a00800946c5.sht ml

PRE-1 Module Status Screen

The PRE-1 module contains a small LED screen that displays the current state of the boot process on the active and standby PRE-1 modules. Table 3-1lists each message and its meaning.

Table 3-1 LED Messages on the PRE-1 Modules

		Message	Description
		BLDRSTRT	The PRE-1 module is starting the boot loader software.
		BLDREXC	The boot loader software has begun to execute.
		BLDRMEM	The boot loader software is initializing the memory on the PRE-1 module.
		BLDRFILE	The boot loader software is initializing the router’s file systems.
		BLDRDRVR	The boot loader software is initializing the driver subsystems.
		BLDRLIB	The boot loader software is initializing the subsystem libraries.
		BLDRPROT	The boot loader software is initializing the protocol subsystems.
		BLDRMGMT	The boot loader software is initializing the management subsystems.
		BLDRINTF	The boot loader software is initializing the router’s interfaces.
		BLDRSTBY	The boot loader software is running and the PRE-1 module is running as the
			standby PRE-1 module.
		LOADIOS	The boot loader software has finished initializing and has begun to load the
			Cisco IOS software.
		IOS STRT	The PRE-1 module is starting the Cisco IOS software.
		IOS EXC	The Cisco IOS software has begun to execute.
		IOS MEM	The Cisco IOS software is initializing the memory on the PRE-1 module.
		IOS FILE	The Cisco IOS software is initializing the router’s file systems.
	Cisco uBR10012 Universal Broadband Router Troubleshooting Guide
3-2			OL-1237-01