Cisco Systems UBR10012 manual Hccp Commands, Mlppp Commands

Appendix A Unsupported Commands

HCCP Commands

•frame-relay map ip ip-address dlci [broadcast] [cisco ietf] [nocompress] tcp header-compression {active passive}

•frame-relay mincir {in out} bps

•frame-relay traffic-rate average [peak]

•frame-relay traffic-shaping

•show frame-relay ip [rtp tcp] header-compression [interface]

HCCP Commands

The following commands are supported in Cisco IOS Release 12.2(8)BC2 and later 12.2 BC releases. These commands are not supported in previous releases.

•hccp authenticate

•hccp authenticate key-chain

•hccp ds-switch

•hccp lockout

•hccp protect

•hccp revert

•hccp reverttime

•hccp switch

•hccp timers

•hccp track

•hccp unlockout

•hccp working

•show hccp

•show hccp interface

•debug hccp authentication

•debug hccp events

•debug hccp sync

MLPPP Commands

The following commands are supported in Cisco IOS Release 12.2(4)BC1 and later 12.2 BC releases. These commands are not supported in previous releases.

•multilink load-threshold

•multilink max-fragments

•ppp multilink fragment-delay

•ppp multilink fragmentation

•ppp multilink idle-link

•ppp multilink interleave

Cisco uBR10012 Universal Broadband Router Troubleshooting Guide

A-2 OL-1237-01