CNET Printer/Fax/Scanner/Copier appendix Press PrevMenu, Press Exit

Configuring the Scanner Settings

H Press [Next]. J Press [Next].

3

“9. MAC Address ” appears as the setup item currently selected.

Note

❒MAC address is a hardware ad- dress that uniquely identifies each machine, and cannot be changed. Press [OK] to see the MAC address of this machine, and then press [Cancel] to return to the System Settings menu.

I By pressing [Next] to display “10. Transmission Speed ” and “11. LAN Type ” as the setup item, se- lect options for each of them in the same way that you have done for setting “7. Network Boot ”.

Important

❒Do not change the setting of “11. LAN Type ” from “ Ethernet ” to “ IEEE 802.11b ” using the con- trol panel of this machine. If you want to change to “IEEE802.11b” to use a wireless LAN card, you need to configure related set- tings by using the Web Status Monitor. See p.186 “Using Wire- less LAN” for details.

“12. Wireless LAN Signal ” ap- pears as the setup item currently selected.

Note

❒When an optional wireless LAN card is in use under infrastruc- ture mode, you can check cur- rent condition of wireless LAN signal by pressing [OK]. When you are finished, press [Cancel] to return to the System Settings menu.

K Press [ PrevMenu]

This returns to the Scanner Fea- tures menu.

L Press [ Exit ].

This exits the Scanner Features menu, and returns to the standby screen that is displayed when you turn the power on.

Important

❒Never turn off the power of this machine before the standby screen is displayed. Doing so can discard all the settings you have configured, and return this machine to its factory default status.

Note

❒Instead of pressing [Exit], you can press a number key to enter another setting menu.

M If you have changed the settings of “7. Network Boot ” and/or “11. LAN Type ”, turn off the power and then back on.

58

www.cnet.ieThe changes to the above settings are activated.