CNET Printer/Fax/Scanner/Copier appendix Scan Size, Scanning Area, Position

Registering Scan Settings

❖Scan Size

This item lets you select the size of the area to be scanned. You can se-

lect from the following options. Auto Detect, A3S, A4S, A4R,

A5S, A5R, 11x17S, 81/2x14S, 8 1 / 2 x13 S, 8 1 / 2 x11 RS,

8 1 / 2 x11 S, 5 1 / 2 x8 1 / 2 R,

51/2x81/2S, B4JIS (Japanese In- dustrial Standard)S, B5JISS, B5JISR, Custom Area Setting

Note

❖Scanning Area

Specify the position where scan- ning ends when [Custom Area Set- ting] is selected in the [Scan Size] list.

Enter the offset from the position specified for [Start Positn.], in mil- limeters or inches.

Note

❒This setting is enabled only

when [Custom Area Setting] is se-	3
lected in the [Scan Size] list.

❒Original sizes that can be auto- detected vary depending on where you place the originals

(on the exposure glass or on the ADF). See ⇒ p.110 “The Origi- nal Sizes Available for Auto De- tection” for details.

❒When [Custom Area Setting] is se- lected, specify the scanning area for [Start Positn.] and [Scanning Area].

❖Position

Specify the position where scan- ning starts when [Custom Area Set- ting] is selected in the [Scan Size] list.

Enter the offset from the reference (start) point in millimeters or inch- es.

Note

❒This setting is enabled only when [Custom Area Setting] is se- lected in the [Scan Size] list.

❒You can select millimeters or inches to specify the position using [Unit of Measure] in [2.Send-

Scan Settings] under the Scanner Features menu. See ⇒ p.61 “Unit of Measure” for details.

❒You can select millimeters or inches to specify the position using [Unit of Measure] in [2.Send- Scan Settings] under the Scanner Features menu. See p.61 “Unit of Measure” for details.

❒Make sure that you specify ver- tical/horizontal positions and scanning areas to be within the available scan area. The availa- ble scan area varies depending on where you place the origi- nals (on the exposure glass or on the ADF).

www.cnet.ie

71