G-2 Clearing Configuration Memory
4.Locate the jumper labeled E50.
1 2 3
Figure G-1. Locating the E50 jumper and pins 1-3 on the system board
5.Remove the jumper from pins 1 and 2, place it on pins 2 and 3 for approximately 30 seconds, then return it to pins 1 and 2.
6.Replace the workstation access panel.
7.Reconnect the network cable and external devices.
8.Plug in the workstation and turn on power.
NOTE: When the CMOS jumper is removed, your passwords will become invalid because the passwords are stored in the configuration memory. You will need to reset your passwords and any special system setups. See Chapter 3, “Intelligent Manageability.”
Writer: M. Church Project: Compaq Professional Workstation AP200 Reference Guide Comments:
File Name:
