Corinex Global manual Corinex Powerline Router User Guide

Powerline Setup through the Ethernet Interface

only selected IP address Only this IP address can remotely manage the Router field to manage the Router. This is an advanced feature and you should enable it only when you have changed the Router access password from its default value to your own setting.

In this screen you can also enable or disable the NAT (Network Address Translation) feature. This feature enables you to connect to the LAN side of your Router more IP hosts (computers), sharing the same single WAN IP address, so most of the users will have this feature switched Enabled. You can change the value of NAT enabling in the NAT Enable/Disable field.

Last value which you can change in this screen is UPNP enabling. UPNP (Universal Pug and Play) is a protocol for seamless managing and configuring UPNP enabled devices. However, most users would like to have it switched off, as UPNP is not very wide-spread, and creates possible security hole if not setup properly. You can change the value of UPNP enabling in the UPNP Enable/Disable field.

After you have entered the values in this screen, you can set them up by clicking on the Submit Query button.

68

3.9Powerline Setup through the Ethernet Interface using Corinex Setup Tool

If you want to change the password on the powerline interface without using web-based utility, you can change it using the Corinex Setup Tool. The computer running Corinex Setup Tool must be connected directly or through the hub to one of the Ethernet LAN ports of the Router (Figure 3.32).

Corinex Powerline Router User Guide