3.1.1Roll Media

This loading method is for roll type media applications. To load:

n Slide the Roll Media

onto the Media Hub

until it rests against the

Backstop.

o Route the media as shown: under the Media Idler, through the Media Sensor, then out the front of the printer.

p Raise and slide the Media Guide over until

it rests lightly against the edge of the media.

qPosition the Media Sensor; see Section 3.2.

rIf your application uses thermal transfer media, load ribbon (see Section 3.3); otherwise continue.

sLower the Printhead Assembly and rotate the Printhead Latch completely back into the locked position. Close the Access Cover.

tTurn ‘On’ the printer. After ‘Ready is displayed, press and hold the FEED Key until at least one label gap or mark is advanced; see Section 3.4.

If using less than full width media, adjust the Leveling Cam; see Section 5.1.1.

18

I-Class

Page 28
Image 28
Datamax 4308, 4212, 4406, 4604, 4208 manual Roll Media