
5.1.2Burn Line Adjustment
The Burn Line has been adjusted at the factory for strict compliance using 6.5- mil (.0065 inch) media, ensuring print quality across a majority of media types. In extreme cases, however, if media of a different thickness or rigidity is used (for example, heavy tag stock), print quality can change. Try the suggestions in Section 2.1.1 and 5.3.1. If print quality remains unacceptable, an adjustment may be required. Typically, thicker media requires a slight forward adjustment, while thinner media requires a slight backward adjustment.
☞If you have questions, contact a qualified technician or Datamax Technical Support before proceeding.
To adjust the Burn Line:
n Load the printer with your media (and ribbon, if required), lower the printhead assembly and rotate the printhead latch back into the locked position.
oLoosen the two Locking Screws approximately ¼ turn
pTurn the Adjustment Screws
qTighten the Locking Screws just until they are ‘snug’ (tight enough to remove any play in the printhead assembly, yet loose enough to allow the Adjustment Screws to move the printhead).
rTurn each Adjustment Screw clockwise about a ¼ turn (or an 1/8 turn for finer adjustments, see note below). Print another Validation Label and examine the print quality. Repeat this step until the labels are produced with even print contrast and acceptable print quality are produced.
;Note: When the Locking Screws are ‘snug’, turning the Adjustment Screws
sTighten the Locking Screws. Print a final Quick Test label to verify the adjustment.
78 |
|