Printer Fault Messages (continued)

 

 

Displayed Message

 

Description

Possible Solution(s)

 

 

 

 

 

 

The Verifier could

Simultaneously

press

the

 

 

 

 

 

 

 

WFSJGJFS!GBVMU

 

 

not successfully

ENTER and F1 Keys on the

 

 

 

 

 

 

pass a bar code.

Verifier to clear. If the fault

 

 

 

 

 

 

 

 

continues consult

the

DMX

 

 

 

 

 

 

; Note: This is a

 

2970 Operators Manual.

 

 

 

 

 

 

normal condition

 

 

 

 

 

 

 

 

 

 

when a bar code is

 

 

 

 

 

 

 

 

 

 

not verifiable.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Warning Messages:

Warning Messages are displayed for a period of five seconds. If multiple warnings are detected, the display will reflect the highest priority message.

Printer Warning Messages

 

Displayed Message

Description

Action(s)

 

 

 

 

The printer has

Replace the printhead if the

 

 

EPU!GBJMVSF

 

detected defective

print quality becomes

 

 

 

printhead elements.

unacceptable.

 

 

 

 

 

 

 

 

 

 

 

 

 

The printer measured

Transparent backing or

 

 

HBQ!NPEF

 

 

XBSOJOH!MPX!CBDLJOH

 

only a small

notched media typically

 

 

 

 

difference between

gives this indication. In this

 

 

 

 

the ‘empty’ and ‘gap’

case, there may be a slight

 

 

 

 

sensor readings.

delay in the ‘Out of Stock’

 

 

 

 

 

indication, after the media

 

 

 

 

 

supply is emptied; no

 

 

 

 

 

action is required.

 

 

 

 

 

 

 

 

 

 

Power has been

The printer power switch

 

 

HPPECZF

 

removed and

was turned ‘Off’, the line

 

 

 

shutdown is in

fuse has blown, or AC line

 

 

 

 

 

 

 

 

progress.

voltage has been lost.

 

 

 

 

 

 

 

 

 

 

The host has pending

To save changes, send a host

 

 

IPTU!DIBOHFT!QFOEJOH

 

configuration

reset command (in DPL), or

 

 

 

changes that will not

to discard changes perform a

 

 

 

 

 

 

 

 

take effect until a

soft reset; see Section

 

 

 

 

‘host reset command’

4.0.6.1.

 

 

 

 

is issued.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

I-Class

 

99

 

Page 109
Image 109
Datamax 4208, 4212, 4406, 4604, 4308 manual Dmx