Standard Calibration (continued)

Step

Operator Action

Displayed Message

Comment

7

Proceed according to

 

 

 

 

This sets the

TDBO!CBDLJOH

 

 

 

your media type:

QSFTT!BOZ!LFZ!!!=zzz?

 

 

parameter for the

 

Die-cut stock: strip the

Or, for reflective media:

‘gap’ or ‘mark’

 

value.

 

media from the backing

 

 

 

 

 

 

 

and then reinsert it into

 

 

Where ‘yyy’ is a

 

TDBO!NBSL

 

 

 

the sensor; adjust the

QSFTT!BOZ!LFZ!!!=zzz?

 

 

numerical value

 

Sensor Eye Mark over

 

 

 

 

representing the

 

the center of the backing.

 

 

 

 

current sensor

 

Notched stock: adjust

 

 

 

 

reading: useful in

 

the Sensor Eye Mark

 

 

 

 

locating the best

 

over the center of the

 

 

 

 

sensor position.

 

notch.

 

 

 

 

 

 

Reflective stock: Adjust

 

 

 

 

; Note: Never

 

 

 

 

 

position the

 

the Sensor Eye Mark

 

 

 

 

 

 

 

 

 

sensor over a

 

over the center of the

 

 

 

 

 

 

 

 

 

perforation when

 

facedown black mark.

 

 

 

 

 

 

 

 

 

recording a

 

Continuous stock: go to

 

 

 

 

sensor reading.

 

Step 8.

 

 

 

 

 

 

Press any key to

 

 

 

 

 

 

continue.

 

 

 

 

 

 

 

 

 

 

 

 

;Note: Do NOT move the position of the Media Sensor after it has been adjusted.

8

Position the label (and backing, if any) under the Sensor Eye Mark.

;Note: If using preprinted media, ensure the label area under the sensor is free of preprinted text, graphics or borders.

Press any key to continue.

TDBO!QBQFS

QSFTT!BOZ!LFZ!!=zzz?

This sets the parameter for the ‘paper’ value.

Where ‘yyy’ is a numerical value representing the current sensor reading.

I-Class

69

Page 79
Image 79
Datamax 4208, 4212, 4406, 4604 Die-cut stock strip, Notched stock adjust, Reflective stock Adjust, Continuous stock go to