Adjusting and
Maintaining the Printer
5.0Media Sensor Calibration
In addition to the Sensor Type selection, Media Sensor calibration ensures that each label is detected correctly and reliably. Perform calibration when the ‘Uncalibrated’ message is displayed. Two different methods are available to calibrate the printer: Standard and Advanced Entry.
5.0.1Standard Calibration
Standard Calibration is appropriate for most media types. During the process, the printhead assembly can be raised for visual access to the media and media sensor. In addition, displayed sensor readings can be used to indicate the best position over the media, which is helpful when using small,
Empty: | No media in the sensor. |
Gap (or Mark): Only the backing, notch, or reflective mark in the sensor.
Paper: |
|
| The label (with the liner attached) in the sensor. | ||||||||||
To perform a Standard Calibration: |
| ||||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Step | Operator Action | Displayed Message | Comment | ||||||||||
1 | (Media should be loaded |
|
| Wait until the | |||||||||
! |
| ||||||||||||
| and the appropriate | VODBMJCSBUFE |
| printer initializes | |||||||||
| Sensor Type selected.) |
|
| (about six | |||||||||
| Turn ‘On’ the printer. |
|
| seconds). | |||||||||
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
| |
2 | Press the |
|
|
|
|
|
|
|
| Key. |
|
| You are entering |
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
| NFOV!NPEF |
| ||||
|
|
|
|
|
|
|
|
| |||||
|
|
|
|
|
|
|
|
|
|
| NFEJB!TFUUJOHT |
| Menu Mode. |
| Raise the printhead | ! |
|
| |||||||||
| assembly. |
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 67 |
