w w w . d e l l . c o m s u p p o r t . d e l l . c o m
Loading Paper
Load Plain Paper Into the Paper Support
1Lift the paper exit tray and extend the paper support.
2Insert paper into the paper support.
3Squeeze and slide the paper guides to rest against the left and right edges and bottom of the paper.
4Lower the paper exit tray.
5Extend the paper exit tray stop to catch paper as it exits the printer.
NOTE: Do not force the paper into the printer.
Print Media Guidelines for the Paper Support
Follow these guidelines when loading specialty print media in the paper support.
Load up to: | Make sure: |
|
|
150 sheets of | • The paper is centered in the paper support. |
plain paper | • The paper guides rest against the right and left edges of the paper. |
| NOTE: Load letterhead paper with the front of the letterhead face down, and the |
| top of the letterhead going into the printer first. |
•The paper guide rests against the bottom edge of the paper.
•You select Draft (select Photo if a photo cartridge is installed), Normal, or Photo print quality.
20 sheets of | • | You remove any paper from the paper support before inserting banner paper. |
banner paper | • You place a stack of banner paper (20 sheets or less) on the top cover of the | |
|
| printer and feed in the first sheet. |
NOTE: You must select A4 Banner or Letter Banner paper size in Print Properties.
Failure to do so will cause a paper jam. See "Paper Problems" on page 81.
•You load the leading edge of the banner paper into the printer against the right side of the paper support.
•You squeeze and slide the paper guide to the left edge of the banner paper.
•You use banner paper designed for inkjet printers.
34
Getting Started
