Replacing An SD vFlash Card
1.Locate the vFlash media slot on the system.
2.To remove the SD vFlash card, push inward on the card to release it, and pull the card from the card slot.
Figure 37. Removing and Installing the SD vFlash Card
1. SD vFlash card | 2. SD vFlash card slot |
3.To install the SD vFlash card, with the label side facing up, insert the
NOTE: The slot is keyed to ensure correct insertion of the card.
4.Press inward on the card to lock it into the slot.
Internal Dual SD Module
NOTE: When the Redundancy option is set to Mirror Mode in the Integrated Devices screen of the System Setup, the information is replicated from one SD card to another.
NOTE: Dual SD cards are not required; the module can operate with only one card in either of the slots but without redundancy.
Removing The Internal Dual SD Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2.Open the system.
3.Locate the internal dual SD module installed on the RIPs card on the IO card on the NDC riser.
4.If applicable, remove the SD card(s).
5.Holding the blue tab, pull the RIPs card along with the dual SD module to remove it from the IO card.
6.Close the system.
7.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
77
