Figure 38. Removing and Installing the Internal Dual SD Module
1. | connector on the I/O card | 2. | internal dual SD module |
3.blue pull tab
Installing The Internal Dual SD Module
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
1.Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
2.Open the system.
3.Locate the J_RIP connector on the IO card on the NDC riser.
4.Align the connectors on the IO card and the RIPs card with the dual SD module located on it.
5.Holding the tab, push the RIPs card with the dual SD module located on it, until it is firmly seated on IO card.
6.Close the system.
7.Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
Internal SD Card
78
