|
| on a component that resides in the specified slot. |
|
|
|
| If the problem persists, the riser card or system board is faulty. See Getting |
|
|
| Help. |
|
|
|
|
E1714 | Unknown Err | The system BIOS has determined that there has | See Getting Help. |
|
| been an error in the system, but is unable to |
|
|
| determine its origin. |
|
E171F | PCIE Fatal Err | The system BIOS has reported a PCIe fatal error | Remove and reseat the PCIe expansion cards. If the problem persists, see |
| B## D## F## | on a component that resides in PCIe configuration | Troubleshooting Expansion Cards. |
|
| space at bus ##, device ##, function ##. |
|
| PCIE Fatal Err | The system BIOS has reported a PCIe fatal error | Reinstall the |
| Slot # | on a component that resides in the specified slot. |
|
|
|
| If the problem persists, the riser card or system board is faulty. See Getting |
|
|
| Help. |
E1810 | HDD ## Fault | The SAS subsystem has determined that hard | See Troubleshooting a Hard Drive. |
|
| drive ## has experienced a fault. |
|
|
|
|
|
E1811 | HDD ## Rbld Abrt | The specified hard drive has experienced a rebuild | See Troubleshooting a Hard Drive. If the problem persists, see your RAID |
|
| abort. | documentation. |
|
|
|
|
E1812 | HDD ## Removed | The specified hard drive has been removed from | Information only. |
|
| the system. |
|
|
|
|
|
E1914 | DRAC5 Conn2 Cbl | DRAC 5 cable is missing or disconnected. | Reconnect the cable. See Installing a RAC Card. |
|
|
|
|
E1915 | IO55 HTSink | Heatsink sensor reports that the chipset IO55 | See Getting Help. |
| Missing | heatsink is missing. |
|
| MCP55 Htsink | Heatsink sensor reports that the chipset MCP |
|
| Missing | heatsink heatsink is missing. |
|
|
|
| |
E1A12 | PCI Rsr Missing | One or all of the PCIe risers is missing, preventing | Reinstall the missing riser card(s). |
|
| the system from powering on. |
|
|
|
|
|
E1A14 | SAS Cable A | SAS cable A is missing or bad. | Reseat the cable. If the problem persists, replace cable. See SAS Controller |
|
|
| Daughter Card. |
|
|
|
|
E1A15 | SAS Cable B | SAS cable B is missing or bad. | Reseat the cable. If the problem persists, replace cable. See SAS Controller |
|
|
| Daughter Card. |
|
|
|
|
E1A1C | LOM Mezz Missing | LOM daughter card is missing. | Install or reseat the LOM daughter card. If the problem persists, replace the |
|
|
| card. See Getting Help. |
E1B01 | USB# Overcurrent | Device plugged in the specified USB port caused | Reseat the device cable. If the problem persists, replace or remove the |
|
| an overcurrent condition. | device. |
E2010 | No Memory | No memory is installed in the system. | Install memory. See Installing Memory Modules. |
E2011 | Mem Config Err | Memory detected, but is not configurable. Error | See Troubleshooting System Memory. |
|
| detected during memory configuration. |
|
|
|
|
|
E2012 | Unusable Memory | Memory is configured, but not usable. Memory | See Troubleshooting System Memory. |
|
| subsystem failure. |
|
|
|
|
|
E2013 | Shadow BIOS Fail | The system BIOS failed to copy its flash image into | See Troubleshooting System Memory. |
|
| memory. |
|
|
|
|
|
E2014 | CMOS Fail | CMOS failure. CMOS RAM not functioning properly. | See Getting Help. |
|
|
|
|
E2015 | DMA Controller | DMA controller failure. | See Getting Help. |
|
|
|
|
E2016 | Int Controller | Interrupt controller failure. | See Getting Help. |
|
|
|
|
E2017 | Timer Fail | Timer refresh failure. | See Getting Help. |
|
|
|
|
E2018 | Prog Timer | Programmable interval timer error. | See Getting Help. |
|
|
|
|
E2019 | Parity Error | Parity error. | See Getting Help. |
|
|
|
|
E201A | SIO Err | SIO failure. | See Getting Help. |
E201B | Kybd Controller | Keyboard controller failure. | See Getting Help. |
|
|
|
|
E201C | SMI Init | System management interrupt (SMI) initialization | See Getting Help. |
|
| failure. |
|
|
|
|
|
E201D | Shutdown Test | BIOS shutdown test failure. | See Getting Help. |
|
|
|
|
E201E | POST Mem Test | BIOS POST memory test failure. | See Troubleshooting System Memory. If problem persists, see Getting Help. |
E201F | DRAC Config | Dell remote access controller (DRAC) configuration | Check screen for specific error messages. |
|
| failure. |
|
|
|
| Ensure that DRAC cables and connectors are properly seated. If problem |
|
|
| persists, see your DRAC documentation. |
|
|
|
|
E2020 | CPU Config | CPU configuration failure. | Check screen for specific error messages. |
|
|
|
|
E2021 | Memory Population | Incorrect memory configuration. Memory | Check screen for specific error messages. See Troubleshooting System |
|
| population order incorrect. | Memory. |
E2022 | POST Fail | General failure after video. | Check screen for specific error messages. |
|
|
|
|
E2110 | MBE DIMM # & # | One of the DIMMs in the set implicated by "# & #" | See Troubleshooting System Memory. |
|
| has had a memory |
|
E2111 | SBE Log Disable | The system BIOS has disabled memory | See Troubleshooting System Memory. |
| DIMM # | error (SBE) logging, and will not resume logging |
|
|
| further SBEs until the system is rebooted. "#" |
|
|
| represents the DIMM implicated by the BIOS. |
|
|
|
|
|
E2112 | Mem Spare DIMM # | The system BIOS has spared the memory because | See Troubleshooting System Memory. |
|
| it has determined that the memory had too many |
|
|
| errors. "# & #" represents the DIMM pair |
|
|
| implicated by the BIOS. |
|
|
|
|
|
|
|
|
|
Page 8
Image 8
