Dukane iQ Series user manual In-lb Ft-lb KHz

Section 6 – Probes and Probe Stacks

6.Thread the components together and tighten to the following torque specifications using only the correct size wrenches. Use spanner wrenches on components with spanner wrench holes or an open end wrench on components with wrench flats. See Figure 6–5 for the correct procedure. Refer to Table 6-III for torque unit conversions. Be careful not to overtighten.

In-lb	Ft-lb	N-m	kHz
540	45	61	15 kHz stack
420	35	47.5	20 kHz stack
216	18	24.4	30 kHz stack
216	18	24.4	40 kHz stack

Table 6-IIIHorn/Booster Torque Unit Conversions

NOTE

Horn and booster torque specifications are higher than stud torque specs. Be sure to tighten the horn or booster joints to the higher torque limits.

Do not tighten the studs to these higher ratings as it may induce unnecessary stress in the assembly.

Dukane Manual Part No. 403-577-01 Page  41