Edimax Technology IC-7000 user manual Event, Trigger

`

IC-7000 CAM User’s Guide

Pan/Tilt IP Surveillance Camera

5.3.1Event

Event settings, including:

-Motion Detection (set 1)

-Motion Detection (set 2)

Individual or both set signal input triggers can be selected.

How to Use Event Settings:

Step 1. Activate Event for either set (Trigger sensitivity will be displayed automatically for MD)

Step 2. After you finished, click Submit; otherwise;

Step 3. Click Default to use factory default settings (sets all to off).

Note: After engaging either type of event, “Save in PC” will be switched on automatically.

5.3.2Trigger

Event trigger image transfer settings, including:

-Save in PC:The image file is saved in your computer.

-Save in Flash Card:The image file is saved in the SD card.

-Mail Image:Send captured event trigger image file by e-mail.

-FTP Image: Send captured event trigger image file by FTP.

-Shutter Timer:Change shutter time for event trigger image capture; Default setting is 2 seconds.

5.4NETWORK SETUP

Network Setup can be used to change the network settings of the IP CAM. The default setting for IP assignment is “static”. Available settings are:

-IP Assignment:Static, DHCP, or PPPoE

-PPPoE settings (PPPoE is the most common type of Broadband Internet connection, where your ISP assigns a different IP address to your connection each time you log on)

-Http Server port settings

-Audio Port Settings

-DNS settings

MAC Address:Displays the Mac address of the IP CAM

IC-7000 USER’S GUIDE PAGE 40/62 Rev. PV1.0