Emerson 540VDC manual Checking hole depth

Installation

5.Drill 2" (51mm) deep holes in prepared surface using the drill bit included in the kit per bolt pattern described in Figure 149 - Floor mounting template. The setter rod should be used as a depth gauge to ensure proper depth. The setter rod is marked with two circles indicating the maximum and minimum hole depth allowed (see Figure 18).

If a hole is drilled too deep, refill the hole with debris to the achieve proper depth.

Figure 18 Checking hole depth

Setter Rod (provided)

Concrete Floor

Depth Marks

2.05"

(52mm)

6. Insert four (4) drop-in concrete expansion anchors into drilled holes.

Figure 19 Inserting anchors

Insert anchor flush with floor .

Use hammer if required.

7.Tap anchors into drilled holes using hammer or mallet. When top of anchor is flush with mounting surface, use setter rod to expand and secure.

Figure 20 Expanding anchors

Strike with hammer to set plug

21	DISCONTINUED
	PRODUCT