CONFIDENTIAL
Paper roll Print position commands GS W
Ver. 10.0 1 p. 191
TM-J2000/J2100
The horizontal motion unit is specified by GS P.
See GS ( E Functions 5 for specifying the paper width.
TM-T90
The horizontal motion unit is specified by GS P.
See GS ( E Functions 5 and 6 for specifying the paper width.
TM-T88III
The horizontal motion unit is specified by GS P.
TM-L90
The horizontal motion unit is specified by GS P.
When a set value of the paper layout (horizontal size of the print area) is smaller than the print
area (initial value of this command), it is not possible to print in the area where the paper layout
(horizontal size of the print area) is exceeded.
See GS ( E Functions 5 for specifying the paper width.
See GS ( E Functions 49 and 50 for the paper layout (origin of layout, horizontal size of print area).
TM-L60II
The horizontal motion unit is specified by GS P.
The paper type, thermal paper or label paper, is selected by a DIP switch:
■Serial interface model: DIP switch [SW2-6]
■Parallel interface model: DIP switch [SW1-7]
TM-P60
The horizontal motion unit is approximately 0.125 mm {1/203 inches}. This value equals one dot
pitch.
See GS ( E Function 5 for specifying the paper width.