CONFIDENTIAL
Paper roll Miscellaneous commands GS ( K
Ver. 10.0 1 p. 443
TM-L90
The following print control modes are available.
This printer selects “Standard print control mode” at setting of (
m
= 0,48).
In printing when m = 3, 4, 51, or 52, the printer starts actual printing after it reaches control speed.
The paper must be fed 10 dots or less in this operation. Therefore, when the printer starts
printing, paper feeding for 10 dots or less without printing might occur.
TM-P60
The following printing control modes are selectable:
When printing ladder bar code (bar code rotated by 90 degrees in page mode), it is printed with
the “printing control mode = fine” regardless of the setting of this command.
m
Print control mode
0, 48 Print control mode when power supply is turned on
1, 49 Standard print control mode
2, 50 Suitable print control mode for printing a fence bar code
3, 51 Suitable print control mode for printing a ladder bar code
4, 52 Suitable print control mode for printing a two dimension code
m
Print control mode
49 High speed
50 Fine