CONFIDENTIAL
Paper roll Bit-image commands FS p
Ver. 10.0 1 p. 208
[Notes] ■This command is not effective when the NV bit image specified by
n
has not been defined.
■In standard mode, this command is effective only when there is no data in the print buffer and the printer
is at the beginning of the line.
■In page mode, the NV bit image is only stored in the print buffer and is not printed.
■If the NV bit image exceeds one line of print area, the printer does not print it.
■The scales for width and height of NV bit images are specified by
m
. Therefore, in page mode with 90° or
270° clockwise-rotated NV bit image, the printer applies print area and dot density from [width: direction
of paper feed, height: perpendicular to direction of paper feed].
■This command is not affected by print modes (such as emphasized, underline, character size, or 90° rotated
characters), except upside-down print mode.
■This command executes paper feed for amount needed for printing the NV bit image regardless of paper
feed amount set by a paper feed setting command.
■After printing the bit image, this command sets the print position to the beginning of the line.
■When printing the NV bit image, selecting unidirectional print mode with ESC U enables printing
patterns in which the top and bottom parts are aligned vertically.
■The NV bit image is defined by FS q.
■NV bit image is printed in the default dot density (dot density of vertical and horizontal direction in
normal mode) defined by GS L <Function 49>.
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-T88III, TM-U220