CONFIDENTIAL
Paper roll Miscellaneous commands GS A
Ver. 10.0 1 p. 452
GS A EXECUTING + SETTING
[Name] Adjust label print starting position
[Format] ASCII GS A
mn
Hex 1D 41
mn
Decimal 29 65
mn
[Range] 0 ≤
m
≤ 255, 0 ≤
n
≤ 255
[Default]
m
= 0,
n
= 0
[Printers not featuring this command] TM-J2000/J2100, TM-T90, TM-T88III, TM-L90, TM-P60, TM-U230, TM-U220,
TM-U210, TM-U300A/B
[Description] Adjusts the label print starting position in a selected direction and by a specified amount from the default
position.
•
m
specifies the adjustment direction as follows:
When the LSB of
m
is 0, the label position is adjusted in the normal direction.
When the LSB of
m
is 1, the label position is adjusted in the reverse direction.
•
n
specifies the adjustment amount as (
n
× vertical motion unit).
[Recommended Functions]
This command is supported only by some printer models and may not be supported by future models.
GS ( E is recommended for adjusting the label print starting position. GS ( E <Function 49> can perform the
same function as this command.
[Notes] ■This command is effective only when label is selected, and it is received just after feeding a label to the
print starting position in the condition shown below:
• When resetting the printer or turning on the power.
• Just after executing FF, GS FF, GS <, or GS A.
• Just after performing paper feed by pressing the paper feed button
■When calculating the adjustment amount, the vertical motion unit (
y
) is used.
■When executing this command, the paper is fed to adjust the print starting position of the current label.
Miscellaneous commands obsolete command
obsolete command