CONFIDENTIAL
Paper roll Mechanism control commands GS V
Ver. 10.0 1 p. 376
After executing a paper cut, a paper feed for 1 mm {16/406 inches} before starting the next
printing can provide the best printing result without uneven paper feeding. If the printer is left
until the next printing after executing a paper cut, feeding paper more than 1 mm {16/406 inches}
can avoid a paper jam inside the autocutter.
TM-P60
The vertical motion unit is approximately 0.125 mm {1/203 inches}. This value equals one dot pitch.
The cutting shapes of (
m
= 0,48) and (
m
= 1,49) are the same as the cutting shape of (
m
= 65)
and (
m
= 66). The setting is partial cut (one point is left uncut). The distance from print head to the
autocutter is about 6.4 mm.
TM-T88III
The vertical motion unit is specified by GS P.
The distance from print head to autocutter is about 15 mm {0.59 inch}.
After executing a paper cut, a paper feed for 1 mm {7/360 inches} before starting the next printing
can provide the best printing result without uneven paper feeding.
TM-U230
The vertical motion unit is approximately 0.176 mm {1/144 inch}. This equals 1/2 dot pitch.
When using Function C, the basic unit is approximately 4 mm {0.16 inch}. The top margin is
approximately 27 mm {1.06 inches}.
TM-U210
Since TM-U210D is not equipped with an autocutter, it can use only Function B. The printer feeds
paper for [manual cutter position + (
n
× approximately 0.176 mm {1/144 inch})].
The distance from print head to autocutter is about 27 mm {1.06 inches} in TM-U210A and
TM-U210B. The distance from print head to emergency cutter is about 20.2 mm {0.8 inch} in
TM-U210D.