CONFIDENTIAL
Paper roll Mechanism control commands GS V
Ver. 10.0 1 p. 375
TM-J2000/J2100
The vertical motion unit is specified by GS P.
The cutting shapes of (
m
= 0,48) and (
m
= 1,49) are the same as the cutting shape of (
m
= 65)
and (
m
= 66). Whether the operation is a full cut or a partial cut (one point is left) is determined by
the installation position of the autocutter. The distance from print head to autocutter is about
24.5 mm {1 inch}.
TM-T90
The vertical motion unit is specified by GS P.
The cutting shapes of (
m
= 0,48) and (
m
= 1,49) are the same as the cutting shape of (
m
= 65)
and (
m
= 66). The setting is partial cut (one point is left) when the printer is shipped. It can be
changed to full cut setting by dealer’s option. The distance from print head to the autocutter is
about 14 mm {0.55 inch}.
After executing a paper cut, a paper feed for 1 mm {7/360 inches} before starting the next printing
can provide the best printing result without uneven paper feeding. If the printer is left until the
next printing after executing a paper cut, feeding paper more than 1 mm {7/360} can avoid a paper
jam inside the autocutter.
TM-L90
The vertical motion unit is specified by GS P.
The cutting shapes of (
m
= 0,48) and (
m
= 1,49) are the same as the cutting shape of (
m
= 65)
(
m
= 66), (
m
= 103) and (
m
= 104). The setting is full cut when the printer is shipped. It can be
changed to partial cut (one point is left) setting by dealer’s option. Don’t use Function <D> after
changing the setting to partial cut.
Whether the operation is a full cut or a partial cut (one point is left) is determined by the
installation position of the autocutter. When selecting paper layout (origin of layout) as “bottom
of a label” or “top of a black mark,” use this command immediately after executing the paper
feed to the cutting position. The distance from print head to autocutter is about 14 mm {0.55
inch}. The top margin is about 3 mm {0.12 inch} when executing Function <D>.