CONFIDENTIAL
Paper roll Customize commands GS ( E
Ver. 10.0 1 p. 579
• Initializing by turning on the power by switch.
• Initializing by hardware reset.
• Initializing by software reset, such as by transmitting Function 2.
• Initializing after the self test.
■With a serial interface, when communication with the printer uses XON/XOFF control, the XOFF code may
interrupt the “Header to NUL” data string.
■With a parallel interface, it is desirable for the host to be in a reverse idle state; however, because the host
computer cannot always be in the reverse idle state, it is necessary to enter reverse mode regularly to
watch for a notice.
[Explanation for memory switch 2] (
a
= 2):]
• Character code system is specified by [Msw2-3] (the third bit) as shown in the following table.:
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-L90, TM-P60, TM-U220
TM-J2000/J2100
Receive buffer capacity [Msw 1-2]: Large (when
b
= 48) = 4 KB; small (when
b
= 49) = 45 bytes
This printer doesn’t support [Msw 2-3] (Selecting character code system for the simplified Chinese
model)
• When
a
= 8, memory switch 8 is set as follows:
Setting the memory switch ([Msw 1-2] ~ [Msw 1-5], [Msw 1-7], [Msw 1-8], [Msw 2-2]) can be
changed by “Memory switch setting mode” by the panel switch operation when the power supply
is turned on.
Character code system Number of characters
GB2312 7,580
GB18030 28,553
Msw Setting value (
b
) Function
8-1 to 8-7 50 Reserved
8-8 48 Roll paper cover open during printing: automatic recoverable error
49 Roll paper cover open during printing: recoverable error