Epson Paper roll Miscellaneous commands GS A, , Ver. 10.0 1 p. 453

CONFIDENTIAL
Paper roll Miscellaneous commands GS A
Ver. 10.0 1 p. 453
■The default and adjustment amounts for the print starting position differ, depending on the printer
model. A setting exceeding the maximum adjustment amount is set to the maximum adjustment amount.
■Adjustment amounts when the print starting position is out of the label cannot be specified.
■Selecting the label paper differs, depending on the printer model.
[Model-dependent variations] TM-L60II
TM-L60II
With a serial interface, the paper selection DIP switch is SW 2-6.
With a parallel interface, the paper selection DIP switch is SW 1-7.
The vertical motion unit is set by GS P.
The default print starting position is approximately 1.5 mm {0.06 inch} below the top edge of the
label.
The maximum adjustment amount in the paper feed direction is (label length – 1.5 mm {0.06 inch}
(top edge) – 1.5 mm {0.06 inch} (bottom edge) – 18 mm {255/360 inch}, and in the reverse direction
it is 0.5 mm {0.02 inch}.
Program Example
PRINT #1, CHR$(&H1D);"A";CHR$(0);CHR$(18);