CONFIDENTIAL
Paper roll Mechanism control commands GS V
Ver. 10.0 1 p. 374
[Notes for <C>] ■Vertical motion unit is used for calculating a paper feed amount.
■Basic paper feed amount differs, depending on the models.
■Paper is fed for the same amount as a cutting range when processing this function.
■The paper will not be cut when this command is executed. When a cutting position reaches an autocutter
position after printing and feeding the next receipt, the printer executes a cutting.
■When a cutting range specified is larger than a top margin (physical distance between the autocutter and
print head), the cutting range is forced to be the amount of the top margin.
■It is possible to set multiple cutting ranges.
■Even if the cutting is set to be large, only one cutting will be executed for each cutting range.
■The cutting range specified is effective until a paper cut is executed, ESC @ is executed, the printer is reset,
or the power is turned off.
■When the printer is not equipped with an autocutter, this command cannot be used.
■The function makes it possible to save paper by reducing the top margin for continuous printing.
[Notes for <D>] ■If an autocutter is not provided, this command is ignored.
■When
n
= 0, the printer feeds the paper to the cutting position and cuts it.
■Vertical motion unit is used for calculating a paper feed amount.
■The function makes it possible to save paper by reducing the top margin for continuous printing.
[Model-dependent variations] TM-J2000/J2100, TM-T90, TM-L90, TM-P60, TM-T88III, TM-U230, TM-U220,
TM-U210
Program Example for all printers Print Sample
PRINT #1, " AAAAA"; CHR$(&HA);
PRINT #1, CHR$(&H1D);"V";CHR$(66);CHR$(0); ← Feed paper and cut Paper fed to the cutting position and
AAAAA
partial cut (one point left uncut)
performed