Epson TM-P60 manual Adjusting Various Settings, How to Confirm Current Settings, DIP switch

2.5 Adjusting Various Settings

This printer is able to be adjusted for the items below:

❏DIP switch (handshake of serial communication conditions)

❏Memory switch (serial communication conditions, roll paper width, print density, etc...)

❏Roll paper width (58mm / 60mm)

Adjusting the spacer and memory switch

The current settings can be confirmed by a self test. (See “3.5.1 Self test mode” (page 3-3).)

Note:

When you adjust these items, we recommend you to confirm the new setting. You can confirm the settings by running a self-test. See “3.5.1 Self test mode” (page 3-3)for detail.

2.5.1 How to Confirm Current Settings

You can use a self-test to confirm the current settings. See “3.5.1 Self test mode” (page 3-3).

2.5.2 DIP switch

This printer has DIP switches 1~4. These are located as shown in the figure below.

1.Make sure the printer is turned off.

2.To access the DIP switches, remove the DIP switch cover by hand (pull out the cover and then pull it upward to release the projection.)

projection DIP switch cover

DIP switch

2-10 Setup Rev. D