Ericsson RX8000 Subnet, Gateway, IP Dest, Bitrate Type, Dest UDP Port, User TX Enable, Service Filter Mode, Output One/Two/Three, Insert Nulls on Failure

Chapter 5

Figure 5.33Output Web Page

The following user-editable fields are displayed on this page.

User-editable fields in the Output section:

•TS (Transport Stream) Feed – allows selection of the type of transport stream output from a drop-down menu.

•Output One/Two/Three – allows selection of the type of output from a drop- down menu.

User-editable fields in the Filter Section:

•Service Filter Mode - allows selection of the Service Filter Mode from a drop- down menu.

•Bitrate Type - allows selection of the Bitrate type from a drop-down menu.

•TS Output Constant Bitrate – allows the user to enter a value in Mbits/s.

Insert Nulls on Failure – checking this box will enure that CBR is maintained even if the Transport stream is unlocked.

User-editable fields in the IP Out 1/IP Out 2 section:

•User TX Enable – checking this box enables the User Transmitter.

•IP – allows input of the IP address.

•Subnet – allows input of the Subnet mask address.

•Gateway - allows input of the gateway address.

•Src UDP (User Datagram Protocol) Port - allows input of the source UDP Port.

•IP Dest - allows input of the IP destination address.

•Dest UDP Port - allows input of the destination UDP port.

5-36 EN/LZT 790 0005 R1A