Ericsson RX8000 Power Supply – AC Mains Input, B.8 Cable Types

Annex B

B.7	Power Supply – AC Mains Input
	This equipment is fitted with a wide-ranging power supply. It is suitable for supply
	voltages of 100-240 V AC -10% +6% at 50/60 Hz nominal.
	Table B.25 AC Power Supply Specification
	Item	Specification
	Power distribution system	Type TN ONLY (EN 60950-1 Annex V): Power distribution
		system which is directly earthed, the parts of the equipment
		required to be earthed being connected by protective
		earthing conductors. This equipment must NOT be used
		with single-phase three-wire and PE, TT or IT Type Power
		distribution systems.
	Connection to supply	Pluggable Equipment Type A (EN 60950-1 para 1.2.5):
		Equipment which is intended for connection to the building
		power supply wiring via a non-industrial plug and
		socket-outlet or a non-industrial appliance Coupler or both.
		Correct mains polarity must always be observed. Do not
		use reversible plugs with this equipment.
	Class of equipment	Class I Equipment (EN 60950-1 para 1.2.4): electric shock
		protection by basic insulation and protective earth.
	Rated voltage	100-240 V AC (single phase)
	Rated frequency	50/60 Hz
	Voltage selection	Wide-ranging
	Rated current	RX83xx: 1 A (100-240 V AC range)
		RX82xx: 1.5 A (100-240 V AC range)
	Input connector	CEE 22/IEC 3-pin male receptacle
	Fuse	Fuse in live conductor in power input filter at rear of unit. Do
		not use reversible plugs with this equipment.
	Fuse type	Bussmann S505
		Littelfuse 215
		5x20 mm time delay (T) 1500 A breaking capacity (HBC)
		IEC/EN 60127-2 Sheet 5
	Fuse current rating	All RX8000 models: 2 A 250 V T HBC
	Power consumption	45 W typical (NO options fitted)
		60 W maximum

B.8 Cable Types

The signal cable types (or similar) in Table B.26 are those recommended by

Ericsson in order to maintain product EMC compliance.

B-20 EN/LZT 790 0005 R1A