
3 Initialisation
3.INITIALISATION and PRECAUTIONS OF USE
3.1.ESCORT 3008B LOADING THE RECORDING PAPER
The paper used for ESCORT 3008B is provided with an end cut so that its loading is made easier. In case of an used roll, youd better cut it again this way.
NOTE: Only one side of the paper is sensible to heat. Reverse it while loading would lead to no printing.
Operations to proceed:
-open the door toward you
-put the axis of the paper inside the roll
-set the axis of the paper together with the roll in place at the bottom of the receptor. The axis must be positioned inside the notches on both sides of the receptor.
The words "ref. no." must appear on the left
-introduce the point of the paper into the slot on the stainless steel receptor
-collect the paper with the point above the roll under the cutter
-pull the paper sheet a few centimetres until it is well positioned
-close the table.
Installation of the roll paper |
A bad loading of the paper could damage the motor and the thermal head.
Special attention should be paid to it.
The recorder should always be provided with paper, for
Page 3.1