SUPREMA 2001 - OPERATION & SERVICE MANUAL

Reminder: The “INCREASE” (+) and “DECREASE” (-) buttons are located to the right of the “START” button, and the “MENU SCROLL UP” and “MENU SCROLL DOWN” buttons are located to the left of the “START” button. See page 4 for illustration.

PRODUCT ON/OFF

!Note:

If the product is switched “OFF”, it remains off until you enter the “SETUP ” mode to switch it “ON” again. Please make sure it is switched “ON” before you leave the account.

This feature allows you to run a complete coffee or hot chocolate cycle (including the two pauses) without any product being dispensed (no coffee or chocolate). This will allow you to manually test brew different coffee blends for the customer to taste. The customer can then decide which blend he prefers. To use it as a test brew cycle, simply weigh and manually pour the coffee grounds into the brew chamber, and press the "START" button. This procedure can be repeated if you need to test brew another blend.

1.To switch the product OFF, press the "UP" button on the hidden menu scroll buttons and scroll until the following message appears,

PRODUCT ON/OFF

PRESS <START>

a)Press the "START" button to enter set mode.

b)Switch the product "OFF" or "ON" by using the hidden setting adjustment buttons. Press the "UP" button to toggle it "OFF" or "ON".

c)To exit the "PRODUCT on-off" mode and proceed to the next setting, press the hidden "UP" or "DOWN" scroll buttons.

SETTING PRODUCTS

!Note:

The minimum allowable setting for all products is

0.5seconds, and the maximum is

8.0seconds.

1.To adjust product settings, press the "UP" button on the hidden menu scroll buttons and scroll until the following message appears,

SET PRODUCT

PRESS <START>

∃Tip:

While in the “SET

PRODUCT” or “SET WATER” menus, you can test the product and water quantities by pressing the “START” button. The product or water tested will correspond to the LED’s illuminated on the front selection panel. Make certain you have something ready to catch the coffee grounds or water that will be dispensed.

a)Press the "START" button to enter the set mode.

b)At this point, you can now select the product settings for any cup size, product and product strength by pressing the appropriate buttons on the selection panel. The time setting displayed will correspond to the LED's that are illuminated.

c)Using the hidden setting adjustment buttons, increase or decrease the timing for the product.

d)To exit the "SET PRODUCT" mode and proceed to the next setting, press the hidden "UP" or "DOWN" scroll buttons.

Suprema 2001 - Operation & Service

July 6, 2001

Page 17 of 60