SUPREMA 2001 - OPERATION & SERVICE MANUAL
MESSAGE | POSSIBLE CAUSE | CORRECTIVE ACTION |
ENTER
SET TEMPERATURE
The rear board is set for a mechanical thermostat, but the machine is equipped with an electronic temperature probe.
(Go to the “SET TEMPERATURE” menu and set the electronic temperature probe.
INCOMPATIBLE
SOFTWARE LEVEL
The software version (EPROM) in the Data Link downloader in not compatible with this equipment and will be downloaded.
(Replace the software version (EPROM) with one that is compatible with the Suprema model. The words “SUPREMA” will be printed on the EPROM decal.
PLEASE CALL FOR | This message is a reminder that regular | |
maintenance may be due and will not | ||
ROUTINE SERVICE | ||
stop the operation of the coffee maker. | ||
|
(The coffee maker is due for routine maintenance.
(To reset the message, enter the
PLEASE CHECK | The brewer harness is not connected to | |
the rear board. | ||
BREWER HARNESS | ||
|
(Connect the brewer harness to the rear board.
PLEASE CHECK | Overflow harness is not connected to | |
the rear board. | ||
OVERFLOW HARNESS | ||
|
(Connect the overflow harness to the rear board.
PLEASE CHECK | The water tank harness is not | |
connected to the rear board. | ||
TANK HARNESS | ||
|
(Connect the water tank harness to the rear board.
PLEASE CHECK | Indicates a problem with the main water | |
supply not getting to the water tank. | ||
WATER SOURCE | ||
|
(At this point, the water tank is not full and this message has to be reset. To reset it, switch the power off and on.
(If the problem persists, check all components on the water line (water filter, tubing, fittings, etc.).
(Check inlet valve to make certain it is functioning properly.
(In the case of a temporary disruption with the water supply, the coffee maker will reset itself after every hour.
PRESS PRODUCT | The "OPEN BREWER" button has been | ( Pressed the "OPEN BREWER" button once |
TO RESET MESSAGE | pressed. | more to close the brewer and exit. |
| ( At this point, pressing the appropriate | |
|
| |
|
| buttons on the front selection panel will |
|
| reset the product counters. |
PROBES | The main level probes are covered with | |
lime/calcium. | ||
CALL FOR SERVICE | ||
|
(The water tank may require deliming.
(The main level probes need to be cleaned/delimed.
SELECTION | Product selected may be disabled. | ( Check the "ENABLE SWITCHES" menu to |
| see if product has been canceled. | |
NOT AVAILABLE |
| |
| ( Check the price of the selection to make | |
|
| |
|
| certain it has not been disabled (set |
|
| below zero). |
Page 40 of 60 | July 6, 2001 | Suprema 2001 - Operation & Service |