SUPREMA 2001 - OPERATION & SERVICE MANUAL

APPLYING THE FASCIA

!Note:

Do not apply any pressure to the fascia until it is placed in the proper position. This way, if it is not in the right place, you can carefully peel it off and re-position it.

7.Apply the fascia to the Suprema front door.

a)Peel the backing paper from the rear of the fascia (Figure 3).

b)Align the fascia inside the plastic trim around the selection panel, making certain that the fascia does not interfere with the buttons.

c)Once aligned, press the fascia firmly in place (Figure 4).

Figure 3 – Remove Backing

APPLYING THE INNER DOOR DECALS

8.Apply the "Care and Maintenance" decal.

a)Open the outer door.

b)Peel off the lower half of the backing paper.

c)Align the upper half of the decal with the right side of the inner door.

d)When satisfied with the alignment, apply the lower portion of the decal to the door surface.

e)Lift the upper portion of the decal and remove the backing paper.

f)Apply pressure to the upper half of the decal, from the center outwards.

9.Apply the "Diagram" decal.

a)Peel the backing from the decal.

b)Align the decal below the inner door grounds deflector.

c)When satisfied with the alignment, apply pressure to the decal.

Figure 4 – Install Fascia

#8

#9

Suprema 2001 - Operation & Service

July 6, 2001

Page 7 of 60