SUPREMA 2001 - OPERATION & SERVICE MANUAL

COIN CHANGER INSTALLATION

INSTALLING THE COIN CHANGER

!Note:

The machine power MUST be switched OFF when connection or disconnecting the coin changer. Failure to do so will damage the coin changer and the electronics in the machine.

To operate this equipment in “COIN” mode, an optional Coinco 9300-series changer must be installed. This changer can be purchased from your local Coinco retailer.

1.Switch the coffee maker "OFF" and open the inner door.

2.Loosen the three changer mounting screws on the inside of the front door.

a)Using a Phillips screwdriver, loosen (but do not remove) the three mounting screws.

3.Remove the ‘Acceptor’ unit from the coin changer.

a)Lift the two locking tabs on top of the coin changer.

b)Pull the acceptor towards you. It will pivot, with the base portion remaining in place.

c)Disconnect the ribbon cable and remove the acceptor.

4.Set the changer to accept and reject certain currencies and denominations of coins.

a)Locate the DIP switches on the inside of the coin changer and adjust them accordingly. Consult the diagram below for the function of each switch.

5.Slide the ‘key-hole’ slots of the changer onto the mounting screws.

a)Having removed the acceptor, you

will see three ‘key-hole’ slots on the rear wall of the changer. Align these slots with the three mounting screws on the inside of the door. It may be necessary to hold the coin reject assembly (on inside top of coffee maker) up and out of the way.

b)Slide the changer down until the three screws line up with the narrow part of the ‘key-hole’ slots.

c) Tighten the three screws enough to secure the changer. Do not over- tighten.

6.Partially fill the pay-out tubes with an appropriate amount of coins.

7.Reconnect the ribbon cable and re-install the ‘Acceptor’ unit.

8.Plug the changer into the receptacle on the inside top of the door.

9.Switch the coffee maker "ON".

Page 58 of 60

July 6, 2001

Suprema 2001 - Operation & Service