SUPREMA 2001 - OPERATION & SERVICE MANUAL
GENERAL INFORMATION!Note:
Updates to this information will be issued as soon as any changes are made and implemented into the programming.
There are several features with this version of software that you should be aware of, and these features are outlined below.
∋If an overflow occurs during a hot chocolate cycle, the machine will stop immediately (anywhere in mid cycle). If an overflow occurs during a coffee vend, the cycle will be completed (without any pauses), and then the unit will stop.
∋A rear overflow will shut everything off, including the heater element. A front overflow will shut off all motors and valves, but will leave the heater element active until the water level drops below the level probes. Power to the element will then be switched off.
∋The "TANK IS FILLING" message appears immediately when the unit is powered up (if tank is not full). The "CHECK WATER SOURCE" message appears if the tank has not been completely filled after five minutes.
∋There are two fuses in the fuse box. The
∋There is only one limit switch for the brewer motor. This switch controls both the pause and the home position. If the brewer does not read the home position, it will run a dry cycle (no water or product) and stop once it reads the home position. If the home position is not found within 24 seconds, the brewer motor will stop and an error message will appear.
∋If the chocolate pump falls out of the home position, it will automatically cycle until it reads the home position, and then it will stop. If the home position is not found within 8 seconds, the pump will stop and an error message will appear on the display.
∋If any blue component harness is not connected to the rear board, a message will appear advising you of the problem. The system will be disabled until the harness is
∋The water tank does not have a mechanical level float and switch. It uses three water level probes – two to activate the inlet valve and a safety probe in case the first two get covered in lime/calcium (which causes the level in the tank to increase too high).
∋After a chocolate pump cycle is complete, the valve will open for 0.2 seconds to rinse the chocolate components.
∋When a mixed beverage is selected (café mocha or mixed powder beverage), it is mixed with regular strength coffee only. It cannot be mixed with decaf, and the strength cannot be changed.
∋As a safety feature, if the "START" button gets jammed (while pressed) an error message appears - the unit will not continuously brew cups.
Page 32 of 60 | July 6, 2001 | Suprema 2001 - Operation & Service |