SUPREMA 2001 - OPERATION & SERVICE MANUAL

REMOVING SHIPPING MATERIALS

2. Lift and place the coffee maker onto your workbench.

WARNING: Never lift the machine by placing your hand underneath the front door. It is not designed to support the weight of the machine, and serious personal injury and/or damage to the unit may occur.

3.Open the outer and inner doors.

a)There are two sets of keys attached to an envelope on the service cord. The keys numbered 8625 are for the outer door. The keys numbered 8645 are for the inner door.

4.Remove all the shipping tape.

a)Shipping tape is found in the following areas: Valve cover, Service cord, Brewer spout, Cup Trays.

WARNING: Do not connect the service cord to the wall outlet at this point as more adjustments are still required to the machine.

CONNECTIONS AND ADJUSTMENTS

When the water tank is drained after testing at the factory, it is possible for the element may remain hot for a short while afterwards and trigger the thermal cut-off switch.

5.Reset the thermal cut-off switch.

a)Remove the valve cover (figure 1) on the front of the hot water tank.

b)Remove the plastic wing-nut securing

the water tank access panel to the top of the machine.

c)

Remove the water tank access panel.

 

d)

Press the “reset” button on the

 

 

thermal cut-off switch (figure 2).

 

6. Re-install the water tank access panel,

Figure 1 - Remove valve cover.

and the valve cover.

 

Figure 2 - Reset the thermal cut-off switch.

Page 6 of 60

July 6, 2001

Suprema 2001 - Operation & Service