SUPREMA 2001 - OPERATION & SERVICE MANUAL

INSTALLING THE WATER TANK

1.Align the tank assembly on its mounting rail, and slide it into the cabinet.

2.Connect the water tank harness to the rear board.

3.Connect the temperature probe harness to the rear board.

4.Connect the wires identified in the table below.

WIRE

CONNECTED TO:

#1-2on General Harness

Whipper Motor

#8-1on General Harness

Whipper Motor

#11-1on Tank Harness

Wire #3-2on Fuse Box Harness

#6 on Tank Harness

Inlet Valve

#1-2on Tank Harness

Inlet Valve

#11 on Fuse Box Harness

Stud #3 on Heater Relay

#13-1(ground wire)

Ground Stud on Rear Board Cover

*For more information about wiring, consult the wiring section of this manual.

5.Connect the inlet valve hose to the bottom of the tank using a hose clamp.

6.Connect the hot water hose to the hot water valve.

7.Connect the chocolate hose fitting to the whipper assembly.

8.Install the valve cover.

REMOVING THE WATER TANK LID ASSEMBLY

1.Remove the water tank from the coffee maker.

a)Refer to the "Removing The Water Tank Assembly" in this manual.

2.Disconnect wires #9 and the wire from the thermal cut-off switch going to the heater element.

3.Disconnect the 3-position wiring receptacle from the water level switch.

4.Disconnect wire #14 going to thermal cut-off switch.

5.Remove the lid assembly.

a)Press the lock latch on the lid to free it.

b)Lift the assembly up and out of the water tank.

INSTALLING THE WATER TANK LID ASSEMBLY

1.Lower the lid assembly into the water tank.

a)Slide the back of the lid into the tank first, and push the front down until the latch engages.

2.Connect wires #9 and the wire from the thermal cut-off switch to the heater element.

3.Connect the 3-position wiring receptacle to the water level switch.

4.Connect wire #14 to thermal cut-off switch.

5.Re-install the water tank.

a)Refer to the "Installing the Water Tank" instructions in this manual.

Suprema 2001 - Operation & Service

July 6, 2001

Page 47 of 60