SUPREMA 2001 - OPERATION & SERVICE MANUAL

SETTING THE TEMPERATURE

!Note:

This feature only functions on equipment using an electronic temperature probe.

∃Tip:

To toggle between Fahrenheit and Celsius, press the “LARGE CUP” button while in the "SET

TEMPERATURE"

menu.

1. To set the temperature of the water in the tank, scroll the menu that reads,

SET TEMPERATURE

PRESS <START>

a)Press the “START” button. The bottom row of the display will now indicate the currently programmed temperature setting.

b)Using the hidden setting adjustment buttons, increase or decrease the temperature for the water tank.

c)When programmed, this will be the maximum temperature to which the water will heat. Once the water has reached this temperature, the heater will switch off.

SETTING THE "WARMING UP" WARNING MESSAGE

a)Press the “START” button to get back to the main menu, and scroll to the “MESSAGES on/off” menu.

b)Press “START” to enter this menu, and scroll to the “TEMP IS TOO LOW” message by pressing the “START” button.

c)This message can be set to “ON –ACTIVE”, “ON-PASSIVE” or “OFF”. If the message is set to “ON-ACTIVE”, the “WARMING UP” message will appear after the temperature in the tank drops about 20° F, and the unit will no longer function until the temperature gets back to its proper operating range. Set to “ON-PASSIVE”, the message will appear on the display, but the unit will continue to function normally.

PROGRAMMING A CUSTOM MESSAGE

!Note:

When entering a custom message, note that the display has two lines of message space with 16 characters on the first line and 15 on the second. Verify that your message fits in the available space.

∃Tip:

Two shortcut keys can be used on the selection panel to speed up programming the custom message. If the “COFFEE” button is pressed, the underlined character will be erased. If any one of the cup size buttons is pressed, the upper case letter “A” will appear over the cursor.

This software allows you to program a custom message to appear on the display. When this function is enabled and the text has been programmed, the message on the display will then toggle back and forth from the "standby" message to your customized message. Upper and lower case letters, numbers and an assortment of symbols are provided as text for setting your custom message.

1.To set a custom message to appear on the display, press the "UP" button on the hidden menu scroll buttons until the following message appears,

CUSTOM MESSAGES

PRESS <START>

a)Press the "START" button to enter the set mode.

b)On the display, you will notice a line underneath the first character. To change this character, use the hidden setting adjustment buttons to scroll to the next or previous characters. Keep scrolling until the character you require is displayed in this location.

c)To proceed to the next character space, press the "START" button and the line will move underneath the next character.

d)Repeat these procedures until your custom message is complete.

e)To save, press either one of the two hidden menu scroll buttons.

Please note that the “CUSTOM MESSAGE” feature must be enabled in the “MESSAGES ON/OFF” menu for it to function.

Page 26 of 60

July 6, 2001

Suprema 2001 - Operation & Service