SUPREMA 2001 - OPERATION & SERVICE MANUAL

REMOVING THE DRAIN VALVE

To remove the drain valve on a plastic water tank, it will be necessary to drain and completely remove the tank from the coffee maker. The drain plug can only be removed from the interior of the water tank.

1.Remove the water tank.

a)Refer to the "Removing the Water Tank" instructions in this manual.

WARNING: To avoid severe burns, make absolutely certain that the heater element is not hot before proceeding!

2.Remove the drain valve.

a)Remove the upper and lower clips on the drain plug.

b)Push drain plug upwards until it goes through the bottom of the tank (to the inside).

c)Remove the tank lid.

d)Reach inside the tank and remove drain plug.

INSTALLING THE DRAIN VALVE

!Note:

The center tube at the bottom of the tank is for the water inlet hose fitting, and the rear tube is not

used.

1.Install the drain valve.

a)Remove tank lid.

b)Add new o-rings to the drain valve.

c)From the top of the tank, push the drain valve through the bottom (front tube).

d)Install the clips. The smaller clip goes on the top slot, and the larger goes on the bottom slot of the drain valve.

Suprema 2001 - Operation & Service

July 6, 2001

Page 49 of 60