SUPREMA 2001 - OPERATION & SERVICE MANUAL
BREWER RINSE CYCLE1.Add VKI approved brewer cleaner to the brew chamber and activate the brewer rinse cycle by pressing the "RINSE CYCLE" button on the control panel inside the front door.
To cancel the rinse cycle if it was pressed accidentally, press any button (except the “START” button) on the front selection panel. This will exit the rinse cycle and return the unit to the “standby” mode.
a)Select the type of rinse cycle required. For a brewer rinse, press the "COFFEE" button on the front selection panel to begin the cycle.
b)The piston will now move to the top of the cylinder, water will pour in, and the brewer will pause for about 5 minutes. During this time, the cleaner will break down all the oils and stains that have accumulated on the brewer.
To cancel the
c)After the 5 minutes have elapsed, the brewer will cycle, dumping the cleaner into the waste container in the process. The brewer will then automatically cycle water seven consecutive times to rinse the cleaner from the brewer. After the rinse cycle is completed, the brewer will stop and the coffee maker will automatically exit the rinse mode.
To cancel the seven rinse cycles, press the “START” button. For proper brewer cleaning, it is recommended that the full cycle be performed.
d)After the rinse cycle is complete, brew a few cups of coffee to re- lubricate the brewer.
WARNING: Make sure the waste container is under the brewer spout to catch the water coming from the brewer (throughout the complete rinse cycle).
Page 34 of 60 | July 6, 2001 | Suprema 2001 - Operation & Service |