4.Select the eth0 (upper Ethernet connector; primary network) device line to highlight it. If there is a network cable present and it is connected to a switch, the status should read Active.
5.Click Deactivate. The status of the eth0 device should now read Inactive.
6.
Figure 12. Ethernet Device Window
7. | Change the Address and Subnet mask fields as required and then click OK. | |
| NOTE: | The Default gateway address field is only required if devices are on |
| different subnets. | |
8. | Navigate back to the Network Configuration window (see figure 11). Select the | |
| eth0 device and then click Activate. | |
VNM Recorder • Recorder Configuration and Hardware Setup | 18 |
