Extron electronic Output, user interface, and control connections, USP 507 • Installation

Output, user interface, and control connections

hRGB/YUV-HD BNC connectors — Connect a display to these for RGB or HD component video output.

RGBHV

R	G	B
/R-Y	/Y	/B-Y

RGBS video

R	G	B
/R-Y	/Y	/B-Y

RGsB/Component Video

(Y, R-Y, B-Y)

R	G	B/
/R-Y	/Y	B-Y

H/	V	S
HV

H/	V	S
HV

H/	V	S
HV

iRGB/YUV-HD15-pin VGA connector — Connect a display to this for RGB or HD component video output.

jOptional output card (DVI connector shown) — Connect a suitable display device to this optional format output connector (as shown, a DVI output).

k l

MTP output — Connect an Extron twisted pair receiver to this port

LAN Ethernet port — Connect the USP 507 to an Ethernet LAN or WAN via this RJ-45 connector. Ethernet control allows the operator to control the processor from a remote location. When connected to an Ethernet LAN or WAN, the device can be accessed and operated from a computer running a standard Internet browser. The Link LED lights green when the USP 507 is connected to an Ethernet LAN, and the Act LED flickers amber, indicating data transmission as the devices communicate.

CDo not connect the MTP cable to the LAN port, or connect the LAN cable to the MTP port.

NDo not use standard telephone cables, as they do not support Ethernet or Fast Ethernet. See Appendix B for correct cabling.

Do not stretch or bend cables. Transmission errors can occur.

mControl device (RS-232) port — The upper 9-pin D-sub connector provides for two-way RS-232 communication. Connect a host computer or control system to it for serial RS-232 or RS-422 control.

The default protocol is 9600 baud, 1 stop bit, no parity, and no flow control.

nAuxilliary switcher follow port — For auxiliary device switching, using a NULL RS-232 cable only, connect an Extron audio switcher/processor, such as the Extron SW 8A, to the lower 9-pinD-sub connector .

When the USP 507 switches input via either a control device RS-232 command or front panel control, the USP 507 and the connected auxiliary device switch inputs. When video is muted or unmuted, frozen or unfrozen, a corresponding audio mute/unmute command is sent to the auxiliary switcher.

oReset button and LED — This button is used to reset the switcher to any one of four different states. The LED indicates the status during the resetting procedure. Refer to the “Resetting the Unit with the Reset Button” section, on page 2-7,for full details.

USP 507 • Installation 2-5