Extron electronic USP 507 Command, ASCII command, Response, Additional description, 4-13, Freeze

Command	ASCII command	Response	Additional description
	(host to processor\⤀	(processor to host\⤀
Auto Memory
Enable	E1AMEM}	Amem1]	Set auto memory on. Previous
			settings for incoming signal are
			auto recalled.
Disable	E0AMEM}	Amem0]	Set auto memory off. Default
			settings are always used
			unless input preset is recalled
			manually.
View setting	EAMEM}	X1)]	View auto memory status.
Advanced Configurations
Test pattern
Set test pattern	E X2)TEST}	TestX2)]	Select test pattern X2).
View test pattern	ETEST}	X2)]	View selected test pattern.
Freeze
Enable	1F	Frz1]	Freeze selected input.
Disable	0F	Frz0]	Unfreeze selected input.
View setting	F	X1)]	View freeze setting.
RGB delay time
Set value	E X3&VDLY}	VdlyX3&]	Set RGB delay.
View setting	EVDLY}	X3&]	View RGB delay setting.
Switch effect
Cut (Blank)	E0SWEF}	Swef0]	Cuts to black between inputs to
			mask switch effect.
Cut (Freeze)	E1SWEF}	Swef1]	Freezes image between inputs
			to mask switch effect.
Fade	E2SWEF}	Swef2]	Fades through to black then
			fades in image.
View setting	ESWEF}	0] (or 1]) (or 2])	View effect setting.
MTP Pre-peaking
Enable	E1OPEK}	Opek1]	Enables pre-peaking on the
			MTP output.
Disable	E0OPEK}	Opek0]	Disables pre-peaking on the
			MTP output.
View setting	EOPEK}	X1)]	View pre-peaking setting.
Front panel lockout (executive mode\⤀
Enable mode 1	1X	Exe1]	Limited front panel
			adjustments only.
Enable mode 2	2X	Exe2]	Lock out entire front panel.
Disable	0X	Exe0]	Adjustments and selections can
			be made from front panel.
View front panel lock status	X	0] (or 1]) (or 2])	Show executive mode status.

NFor full lock mode details, refer to chapter 3, “Setting the Front Panel Locks (Executive Modes).

NX1) = Off/disable/none (0), on/enable (1)

X2) = Test patterns:	0	= off (default), 1 = color bars, 2 = crosshatch, 3 = 4x4 crosshatch, 4 = grayscale,
	5	= ramp, 6 = alternating pixels, 7 = white field, 8 = crop, 9 = 1.33 aspect ratio,
	10		= 1.78 aspect ratio, 11 = 1.85 aspect ratio, 12 = 2.35 aspect ratio, 13 = safe area,
X3& = RGB delay	14		= blue mode
	0 to 50, in 0.1 second increments (default is 05 = 0.5 seconds)
			USP 507 • SIS Programmer’s Guide	4-13